Audi A3 Quiz
Body

Removing and Installing Window Regulator Motor

In this manual: Body
Owner's Manual — 42Routine Care and Maintenance — 32Engine — 22Engine Cooling System — 9Ventilation, Heating and Air Conditioning Systems — 11Fuel System — 9Fuel Injection System — 4Diesel engine injection system — 5Exhaust System — 9Electronic Ignition and Fuel Injection Control System — 6Charging and Starting Systems — 12Manual transmission — 12Clutch and Drive Shafts — 6Brake System — 13Front Suspension — 5Rear Suspension — 6Steering — 7Body — 70Body Electrical Equipment — 37Wiring Diagrams — 35
~1min read

GENERAL INFORMATION

CAUTION

The window regulator motor can be removed and installed in any position.

REMOVAL

PROCEDURE

1. Remove the door trim panel. Refer to Removal and Installation of Door Trim Panel.

2. Remove the holder. Refer to subsection Removing and Installing Front Door and Adjusting Element Holder.

3. Unscrew the Torx T30 screws (arrows).

4. Remove the motor.

INSTALLATION

PROCEDURE

1. Install the motor in place.

2. Tighten the Torx screws to 6.5 N·m.

3. Install the holder. Refer to subsection Removing and Installing Front Door and Adjusting Element Holder.

4. Install the door trim panel. Refer to subsection Removing and Installing Door Trim Panel.

Test yourself

A quick Audi A3 quiz: every answer comes with an explanation and a link to the manual page.