System Settings

You can customize some of the vehicle system settings. The table below lists the systems that you can customize.

*1: This setting can be changed while driving
*2: For right-hand drive vehicles only
*3: Factory settings
*4: For "Type-R" models

To enter the settings mode, stop the vehicle with the ignition switch in the ON (II) position and apply the parking brake. (This requirement does not apply to some speed alarm settings.) In normal operating mode, press and hold the INFO button on the steering wheel for at least 3 seconds. The following settings modes are available:

SPEED ALARM: Sets the speed alarm function (see page 112).

CHG SETTING (Change settings):

Customizes some vehicle system settings (see page 117).

LANGUAGE: Selects the display language for messages (see page 130).

DEFAULT ALL (Reset all settings):

Resets all settings to the factory defaults (see page 132).

Each time you press the INFO button, the current display changes in sequence to "SPEED ALARM", "CHG SETTING", "LANGUAGE", "DEFAULT ALL", "EXIT", and then returns to "SPEED ALARM" as shown above.

If you select a speed at which the speed alarm will sound while the vehicle is moving, select the "SPEED ALARM" menu item and follow the instructions on page 115. As an exception, you can select the speed alarm setting without stopping the vehicle.

If you need to change any other settings, select the "CHG SETTING" menu item and follow the instructions on page 117.

To return all settings to the factory defaults, select the "DEFAULT ALL" menu item (see page 132).

To select a setting, press the INFO button (), located on the steering wheel hub, and confirm your selection by pressing the SEL/RESET button.

If you do not press any button for 10 seconds after pressing the INFO button and the settings menu appears, the display returns to normal operating mode.

If the vehicle starts moving while settings are being changed, the message "MUST STOP AND PARK TO CHANGE SETTINGS" appears on the display and the settings mode is cancelled.

The settings mode is also cancelled when the ignition switch is turned out of the ON (II) position.