Brake Control / Dynamic Control Systems

Calibration

~2min read

CALIBRATION

DESCRIPTION

(a) Refer to the table below, then perform the operation required for the replaced part to carry out calibration.

Parts to Replace

Operation to Perform

Skid control ECU (brake actuator assembly)

Perform System Variant Learning

SYSTEM VARIANT LEARNING (when using TECHSTREAM)

(a) Perform system variant learning.

HINT:

  • System variant learning is performed automatically immediately after switching to Test Mode.
  • If learning has not yet been performed, the skid control warning light will remain on and DTC C1288 (ECU mismatch error) will be stored.
  • If system variant learning has not been performed correctly, the warning lights do not flash in Test Mode and DTC C1288 is not cleared.
  • When switching to Test Mode, the skid control ECU (brake actuator assembly) communicates with the millimeter wave radar sensor assembly and determines whether the vehicle is equipped with a pre-collision safety system. Therefore, do not exit Test Mode within 5 seconds after switching to Test Mode. (with pre-collision safety system)

(1) Turn the ignition switch OFF.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to the ON position.

(4) Turn on the Techstream.

(5) Switch the skid control ECU (brake actuator assembly) to Test Mode using the Techstream. Select the following menus: Chassis / ABS/VSC/TRAC/EPB / Utility / Test Mode.

Chassis > ABS/VSC/TRAC/EPB > Utility

Test Mode

(6) Check that the ABS warning light and skid control warning light flash in Test Mode.

HINT:

  • After the skid control ECU (brake actuator assembly) switches to Test Mode, the skid control warning light may remain on for approximately 7 seconds before it starts flashing in Test Mode.
  • Do not exit Test Mode within 5 seconds after switching to Test Mode. If Test Mode is exited within 5 seconds after switching to it, DTC U0235 may be stored. If DTC U0235 is output after exiting Test Mode, switch to Test Mode again, wait at least 5 seconds, then check the DTCs again. (with pre-collision safety system)

(7) Turn the ignition switch OFF and disconnect the Techstream.