Brake Control / Dynamic Control Systems

Brake Hold Operation Light Circuit

4steps
~24min
2/5difficulty
Done 0 of 4

DESCRIPTION

The brake hold operated indicator light comes on when the brake hold system is operating (the vehicle is held stationary by brake fluid pressure) and turns off when brake hold system operation ends (brake fluid pressure decreases).

The brake hold system may not operate depending on vehicle operating conditions, even when the system is in standby mode and the brake hold standby indicator light is on.

When a malfunction occurs in the brake control system, the brake hold operated indicator light flashes.

PRECAUTION / NOTICE / HINT

NOTICE:

When the skid control ECU (brake actuator assembly) is replaced, perform zero point calibration and store the system information.

Click here

PROCEDURE

  1. PRELIMINARY CHECKS

(a) Make sure the brake hold standby indicator light operates correctly.

(b) If the brake hold operated indicator light does not come on while the brake hold standby indicator light is on, make sure the following brake hold operating conditions (brake fluid pressure maintained) are met.

  1. Shift lever in a position other than P or R.
  2. The driver depresses the brake pedal and the vehicle is completely stopped.
  3. The driver does not depress the accelerator pedal.
  4. The vehicle is not on a steep slope.

HINT:

When a malfunction occurs in the brake control system, the brake hold operated indicator light flashes.

NEXT
  1. CHECK COMBINATION METER ASSEMBLY

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch OFF.

(c) Perform the Active Test of the combination meter assembly using the Techstream.

Click here

Body Electrical > Combination Meter > Active Test

Indicat. Hold

(d) Check the combination meter assembly.

OK:

The brake hold operated indicator light turns on or off according to the Techstream operation.

NG

CHECK METER / GAUGE SYSTEM

OK
  1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (BRAKE HOLD OPERATED INDICATOR LIGHT)

(a) Turn the ignition switch to ON.

(b) Select the Active Test mode on the Techstream.

Click here

Chassis > ABS/VSC/TRAC/EPB > Active Test

Tester display

Item

Control Range

Diagnostic Note

BH Operated Light

Brake Hold Operation Light

Light on / off

Inspect the combination meter

(c) Select the Data List on the Techstream.

Click here

Chassis > ABS/VSC/TRAC/EPB > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

BH Operated Light

Brake Hold Operation Light

ON or OFF

ON: Indicator on

OFF: Indicator off

-

Chassis > ABS/VSC/TRAC/EPB > Active Test

BH Operated Light

BH Operated Light

(d) Check the operating condition of the brake hold operated indicator light when it is activated using the Techstream.

Result:

Result

Proceed to

The brake hold operated indicator light in the Data List does not change with the Active Test.

A

The brake hold operated indicator light in the Data List is set to ON/OFF with the Active Test.

B

A

REPLACE BRAKE ACTUATOR ASSEMBLY

B

USE SIMULATION METHOD TO CHECK