Brake Control / Dynamic Control Systems

ABS Solenoid Relay Circuit Open (C146E)

~1min read

DESCRIPTION

The ABS solenoid relay is built into the skid control ECU of the brake actuator assembly. The solenoid relay supplies power to the ABS solenoid and the TRAC solenoid. The skid control ECU detects a malfunction in the solenoid relay by performing a self-diagnosis and checking the relay operation.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C146E

Open in ABS Solenoid Relay Circuit

One of the following conditions is detected:

  • A solenoid relay drive circuit in the skid control ECU is malfunctioning.
  • The solenoid relay cannot switch from ON to OFF.

ABS Solenoid Relay (Brake Actuator Assembly)

DTC Detection Conditions: C146E

Vehicle Operating Conditions

Sequence 1

Sequence 2

Diagnostic Condition

-

-

-

Malfunction Status

A solenoid relay drive circuit in the skid control ECU is malfunctioning.

○

-

The solenoid relay cannot switch from ON to OFF.

-

○

Detection Duration

-

-

Number of Trips

1 trip(s)

1 trip(s)

HINT:

The DTC is output when the conditions for any one of the sequences in the table above are met.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the Skid Control ECU (Brake Actuator Assembly), perform system variant coding.

Click here

PROCEDURE

  1. REPLACE BRAKE ACTUATOR ASSEMBLY

(a) Replace the ABS solenoid relay (brake actuator assembly).

Click here

NEXT

END