Brake Control / Dynamic Control Systems

Slip indicator light stays on

~2min read

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

The slip indicator light flashes while the VSC and/or TRAC system is operating.

If a malfunction is detected, the slip indicator light comes on to warn the driver.

Click here

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the Skid Control ECU (Brake Actuator Assembly), perform system variant coding.

Click here

PROCEDURE

  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check whether CAN communication system DTCs are output.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

INSPECT CAN COMMUNICATION SYSTEM

A
  1. CHECK THAT BRAKE ACTUATOR ASSEMBLY CONNECTOR IS PROPERLY CONNECTED

(a) Check that the skid control ECU (brake actuator assembly) connector is properly connected.

OK:

The connector is correctly connected.

NG

CONNECT CONNECTOR TO ECU PROPERLY

OK
  1. CHECK BATTERY

(a) Check the battery voltage.

Standard voltage:

11 à 14 V

NG

CHECK OR REPLACE CHARGING SYSTEM COMPONENT OR BATTERY

OK
  1. CHECK COMBINATION METER ASSEMBLY

(a) Perform an Active Test of the combination meter assembly using the Techstream.

Click here

Body Electrical > Combination Meter > Active Test

Indicat. Lamp Slip

(b) Check the combination meter assembly.

OK:

The slip indicator light turns on and off depending on the Active Test operation.

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

CHECK METER / GAUGE SYSTEM