Brake Control / Dynamic Control Systems

Check for Intermittent Problems

~2min read

CHECK FOR INTERMITTENT PROBLEMS

CHECK FOR INTERMITTENT PROBLEMS

HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the Techstream Data List function.

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Follow the Techstream instructions to display the Data List and select the items to monitor for momentary interruptions.

HINT:

  • A momentary interruption (open circuit) can only be detected 3 seconds after the ignition switch is turned ON (initial check).
  • If the Error message remains displayed for any item on the Techstream, check the continuity between the ECU and the item for which the Error message is displayed.
  • If a momentary interruption occurs and the Error message is displayed on the Techstream, the message will remain displayed for 1 second after the circuit returns to normal.
Chassis > ABS/VSC/TRAC/EPB > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

EFI Communication Open

Detection of EFI communication open

Error or Normal

Error: Momentary interruption

Normal: Normal

-

Yaw Rate Open

Detection of yaw rate sensor open circuit

Error or Normal

Error: Momentary interruption

Normal: Normal

-

Deceleration Open

Detection of acceleration sensor open circuit

Error or Normal

Error: Momentary interruption

Normal: Normal

-

Steering Open

Detection of steering angle sensor open circuit

Error or Normal

Error: Momentary interruption

Normal: Normal

-

IG Voltage Value Decreased

Detection of +BS voltage value decrease

Error or Normal

Error: Low voltage

Normal: Normal

-

IG Voltage Value Increased

Detection of +BS voltage value increase

Error or Normal

Error: High voltage

Normal: Normal

-

(f) While watching the screen, lightly shake the connector or wire harness between the ECU and the sensors, or between the ECUs.

OK:

The Normal message is displayed.

HINT:

If the display changes, there is a momentary interruption (open circuit) in the connector and/or wire harness. Repair or replace the connectors and/or wire harnesses if any of these are faulty.