Brake Control / Dynamic Control Systems

Symptom Table

~3min read

SYMPTOM TROUBLESHOOTING TABLE

If no DTC is output and the problem persists, check the circuits for each problem symptom in the order shown in the following table, then go to the troubleshooting page indicated.

NOTICE:

When replacing the skid control ECU (brake actuator assembly), sensors, etc., turn the ignition switch to OFF.

HINT:

  • Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
  • Check the fuses and relays associated with this system before checking the suspected areas listed below.
Vehicle Stability Control System

Symptom

Suspected Area

Link

ABS warning light malfunction (remains on)

Refer to the procedure in the "ABS Warning Light Remains On" section

ABS warning light malfunction (does not come on)

Refer to the procedure in the "ABS Warning Light Does Not Come On" section

Brake warning light / red malfunction (remains on)

Refer to the procedure in the "Brake Warning Light Remains On" section

Brake warning light / red malfunction (does not come on)

Refer to the procedure in the "Brake Warning Light Does Not Come On" section

Standby brake hold warning light malfunction

Refer to the procedure described in the "Brake Hold Warning Light Circuit" section

Brake hold warning light malfunction (operating)

Refer to the procedure described in the "Brake Hold Warning Light Circuit" section

Skid warning light malfunction (remains on)

Refer to the procedure in the "Skid Warning Light Remains On" section

Skid warning light malfunction (does not come on)

Refer to the procedure in the "Skid Warning Light Does Not Come On" section

TRAC does not operate

Refer to the procedure in the "TRAC Does Not Operate" section

Brake pedal travel (no fluid leaks and no air in system)

Refer to the procedure in the "Brake Pedal Travel (No Fluid Leaks and No Air in System)" section

ABS does not operate

Refer to the procedure in the "ABS Does Not Operate" section

ABS operates before it is needed during braking

Refer to the procedure in the "ABS Operates Before It Is Needed During Braking" section

VSC does not operate or does not operate properly

Refer to the procedure in the "VSC Does Not Operate or Does Not Operate Properly" section

Brake actuator operating noise is loud during initial check

Refer to the procedure in the "Brake Actuator Operating Noise Is Loud During Initial Check" section

VSC OFF switch malfunction

Refer to the procedure in the "VSC OFF Switch Circuit" section