Brake Control / Dynamic Control Systems

Slip indicator light does not come on

~2min read

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the Skid Control ECU (Brake Actuator Assembly), perform system variant coding.

Click here

PROCEDURE

  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check whether CAN communication system DTCs are output.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

INSPECT CAN COMMUNICATION SYSTEM

A
  1. READ VALUE USING TECHSTREAM (SLIP INDICATOR LIGHT)

(a) Connect the Techstream to the DLC3.

(b) Start the engine.

(c) Select the Active Test using the Techstream.

Click here

Chassis > ABS/VSC/TRAC/EPB > Active Test

Tester display

Item

Control Range

Diagnostic Note

Slip Indicator Light

Skid Control Warning Light

Light on / off

Inspect the instrument cluster assembly

Chassis > ABS/VSC/TRAC/EPB > Active Test

Slip Indicator Light

(d) Make sure the slip indicator light on the combination meter turns on and off depending on the Techstream operation.

OK:

The slip indicator light turns on and off depending on the Active Test operation.

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG
  1. CHECK COMBINATION METER ASSEMBLY

(a) Turn the ignition switch OFF.

(b) Perform an Active Test of the combination meter assembly using the Techstream.

Click here

Body Electrical > Combination Meter > Active Test

Indicat. Lamp Slip

(c) Check the combination meter assembly.

OK:

The slip indicator light turns on and off depending on the Active Test operation.

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

CHECK METER / GAUGE SYSTEM