Brake Control / Dynamic Control Systems

Acceleration Sensor Malfunction (C1420)

~1min read

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) detects an abnormality in the difference between the acceleration sensor value and the estimated control value based on the yaw sensor command, steering angle sensor and wheel speed sensor signals.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1420

Acceleration sensor malfunction

The difference between the acceleration sensor value and the estimated control value inside the Skid Control ECU (Brake Actuator Assembly) is not normal.

  • Sensor Installation
  • Acceleration Sensor (Airbag Sensor Assembly)

PROCEDURE

  1. CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION

(a) Check that the yaw rate and acceleration sensor (airbag sensor assembly) is installed correctly.

Click here

OK:

The airbag sensor assembly is tightened to the specified torque.

The airbag sensor assembly is not installed in the correct (level) position.

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

OK

REPLACE AIRBAG SENSOR ASSEMBLY

NG

INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY