Brake Control / Dynamic Control Systems

Acceleration Sensor Malfunction (Stuck) (C1243, C1245)

~3min read

DESCRIPTION

The Skid Control ECU (Brake Actuator Assembly) receives signals from the yaw rate and acceleration sensor (Airbag Sensor Assembly) via the CAN communication system.

A yaw rate and acceleration sensor is built into the airbag sensor assembly, which detects vehicle operating conditions using 2 circuits (GL1, GL2).

If a problem occurs in the bus lines between the yaw rate and acceleration sensor (airbag sensor assembly) and the CAN communication system, DTC U0123 (Lost Communication with Yaw Rate Sensor Module) is output.

These DTCs are also output if calibration is incomplete.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1243

Acceleration sensor malfunction (stuck)

One of the following conditions is detected:

  • The output values of GL1 and GL2 remain unchanged at least 16 times while the vehicle speed decreases from 30 km/h to 0 km/h.
  • The output values of GL1 and GL2 (front and rear, left and right) are outside the allowable output voltage range for at least 60 seconds.
  • The left and right output values of GL1 and GL2 are outside the allowable output voltage range for at least 60 seconds.
  • Acceleration Sensor (Airbag Sensor Assembly)
  • Acceleration Sensor Circuit (Airbag Sensor Assembly)
  • Sensor Installation

C1245

Acceleration sensor output malfunction

When the vehicle is driven at 30 km/h or more, the difference between the front and rear G calculated from the acceleration sensor values and the G calculated from the vehicle speed values is greater than 0.35 G for at least 60 seconds.

  • Acceleration Sensor (Airbag Sensor Assembly)
  • Acceleration Sensor Circuit (Airbag Sensor Assembly)
  • Sensor Installation
DTC Detection Conditions: C1243

Vehicle Operating Conditions

Sequence 1

Sequence 2

Sequence 3

Diagnostic Condition

-

-

-

-

Malfunction Status

The output values of GL1 and GL2 remain unchanged at least 16 times while the vehicle speed decreases from 30 km/h to 0 km/h.

○

-

-

The output values of GL1 and GL2 (front and rear, left and right) are outside the allowable range.

-

○

-

The left and right output values of GL1 and GL2 are outside the allowable range.

-

-

○

Detection Duration

-

60 seconds or more

60 seconds or more

Number of Trips

1 trip(s)

1 trip(s)

1 trip(s)

HINT:

The DTC is output when the conditions for any one of the sequences in the table above are met.

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration and register system information.

Click here

HINT:

If DTCs U0073, U0123 and/or U0126 are output together with DTCs C1243 and/or C1245, first check and repair the parts indicated by DTCs U0073, U0123 and/or U0126.

Click here

PROCEDURE

  1. CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION

(a) Check that the yaw rate and acceleration sensor (airbag sensor assembly) is installed correctly.

Click here

OK:

The airbag sensor assembly is tightened to the specified torque.

The airbag sensor assembly is not installed in the correct (level) position.

NOTICE:

Check the yaw rate and acceleration sensor signal after replacement.

Click here

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

OK

REPLACE AIRBAG SENSOR ASSEMBLY

NG

INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY