Brake Control / Dynamic Control Systems

Pump Motor Circuit Malfunction (C1428)

~2min read

DESCRIPTION

This DTC is stored when the Skid Control ECU (Brake Actuator Assembly) determines that a malfunction has occurred in the circuit used to operate the pump motor.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1428

Motor circuit malfunction

A malfunction occurs in the pump motor circuit.

Pump Motor Circuit

WIRING DIAGRAM

Refer to DTC C146C.

Click here

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the Skid Control ECU (Brake Actuator Assembly), perform system variant coding.

    Click here

  • Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK WIRE HARNESS AND CONNECTOR (+BM TERMINAL)

(a) Make sure there is no looseness in the lock and connector connection.

*a

Front view of wire harness side connector

(to Skid Control ECU (Brake Actuator Assembly))

(b) Disconnect the A42 connector from the Skid Control ECU (Brake Actuator Assembly).

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

A42-1 (+BM) - Body ground

Always

11 à 14 V

NG

REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR (+BM CIRCUIT)

OK
  1. CHECK WIRE HARNESS AND CONNECTOR (GND2 TERMINAL)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

A42-14 (GND2) - Body ground

Always

Below 1 Ω

*a

Front view of wire harness side connector

(to Skid Control ECU (Brake Actuator Assembly))

NG

REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR (GND2 CIRCUIT)

OK
  1. CONFIRM DTC AGAIN

(a) Reconnect connector A42 to the skid control ECU (brake actuator assembly).

(b) Clear the DTCs.

Click here

Chassis > ABS/VSC/TRAC/EPB > Clear DTCs

(c) Turn the ignition switch to OFF.

(d) Start the engine.

(e) Perform a road test.

(f) Check whether the same DTC is output.

Click here

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

Result:

Result

Proceed to

DTC C1428 is not output.

A

DTC C1428 is output.

B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE BRAKE ACTUATOR ASSEMBLY