Brake Control / Dynamic Control Systems

ABS warning light does not come on

~2min read

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the Skid Control ECU (Brake Actuator Assembly), perform system variant coding.

Click here

PROCEDURE

  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check whether CAN communication system DTCs are output.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

INSPECT CAN COMMUNICATION SYSTEM

A
  1. PERFORM ACTIVE TEST USING TECHSTREAM (ABS WARNING LIGHT)

(a) Select the Active Test mode on the Techstream.

Click here

Chassis > ABS/VSC/TRAC/EPB > Active Test

Tester display

Item

Control Range

Diagnostic Note

ABS Warning Light

ABS Warning Light

Light on / off

Inspect the instrument cluster assembly

Chassis > ABS/VSC/TRAC/EPB > Active Test

ABS Warning Light

(b) Select the Data List on the Techstream.

Click here

Chassis > ABS/VSC/TRAC/EPB > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

ABS Warning Light

ABS Warning Light

ON or OFF

ON: Indicator on

OFF: Indicator off

-

Chassis > ABS/VSC/TRAC/EPB > Data List

ABS Warning Light

(c) Check the operating condition of the ABS warning light when it is activated using the Techstream.

Result:

Result

Proceed to

The ABS warning light in the Data List does not change when the Active Test is performed.

A

The ABS warning light in the Data List is turned on/off using the Active Test.

B

A

REPLACE BRAKE ACTUATOR ASSEMBLY

B
  1. CHECK COMBINATION METER ASSEMBLY

(a) Perform the Active Test of the combination meter assembly using the Techstream.

Click here

Body Electrical > Combination Meter > Active Test

Indicat. Lamp ABS

(b) Check the combination meter assembly.

OK:

The ABS warning light turns on and off according to the Techstream operation.

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

NG

CHECK METER / GAUGE SYSTEM