Brake Control / Dynamic Control Systems

Diagnostic System

~3min read

DIAGNOSTIC SYSTEM

DESCRIPTION

When troubleshooting a vehicle using a diagnostic system, the only difference from conventional troubleshooting procedures is that the Techstream must be connected to the vehicle and the various data output by the skid control ECU (brake actuator assembly) must be read.

The skid control ECU (brake actuator assembly) stores DTCs when it detects a malfunction in the ECU or its circuits.

To check DTCs, connect the Techstream to the vehicle's DLC3. The Techstream can also clear DTCs, activate the various actuators, and check freeze frame data and the Data List.

(a) Check the battery voltage.

Standard voltage:

11 à 14 V

If the voltage is below 11 V, recharge the battery before proceeding to the next step.

(b) Check DLC3.

Click here

DIAGNOSIS

(a) If a malfunction occurs in a system component, the skid control ECU (brake actuator assembly) turns on the warning light for the malfunctioning system (ABS warning light, brake system warning light (red), or skid control indicator light) or flashes the brake hold operation indicator light.

(b) DTCs are also stored in memory. DTCs can be read by connecting the SST between terminals TC and CG of DLC3 and observing the flash pattern of the ABS and skid control warning lights, or by connecting the Techstream.

Click here

(c) This system has a test mode (signal check) function.

DTCs can be read by connecting the SST between terminals TS and CG of DLC3 and observing the flash pattern of the ABS and skid control warning lights, or by connecting the Techstream.

Click here

INITIAL WARNING LIGHT CHECK

(a) When the ignition switch is turned ON, check that the ABS warning light, brake system warning light (red), VSC OFF indicator light, multi-information display (TRAC OFF message), brake hold standby light, brake hold operation light, and skid control indicator light come on for about 3 seconds.

HINT:

  • If the brake fluid level is low, the brake system warning light (red) comes on.
  • If any light does not come on, check the communication line between the combination meter assembly and the skid control ECU (brake actuator assembly).
  • If the ABS warning light or skid control indicator light remains on after about 3 seconds, or the brake hold operation light flashes, check for DTCs and inspect the corresponding code. If no DTCs are output, check the communication line between the combination meter assembly and the skid control ECU (brake actuator assembly).

Suspected Area

See procedure

ABS Warning Light Circuit (Remains On)

ABS Warning Light Circuit (Does Not Come On)

Brake System Warning Light (Red) Circuit (Remains On)

Brake System Warning Light (Red) Circuit (Does Not Come On)

TRAC OFF Indicator Light Circuit (Remains On)

TRAC OFF Indicator Light Circuit (Does Not Come On)

VSC OFF Indicator Light Circuit (Remains On)

VSC OFF Indicator Light Circuit (Does Not Come On)

Skid Control Warning Light Circuit (Remains On)

Skid Control Warning Light Circuit (Does Not Come On)

Brake Hold Standby Light Circuit

Brake Hold Operation Light Circuit