Brake Control / Dynamic Control Systems

ABS does not operate

~2min read

DESCRIPTION

When the vehicle stability control system is operating, since the input piston and output piston are not directly connected, brake pedal vibration is minimized during ABS operation and the driver may notice that ABS has been activated.

PRECAUTION / NOTICE / HINT

NOTICE:

When replacing the Skid Control ECU (Brake Actuator Assembly), perform system variant coding.

Click here

PROCEDURE

  1. BRAKING PROBLEM CHECK

(a) Check whether the skid control indicator was on or flashing when the ABS did not operate.

HINT:

  • When the VSC system is normal and ABS is operating, the skid control indicator flashes.
  • When the VSC system malfunctions, the skid control indicator comes on.

Result:

Result

Proceed to

The skid control indicator was flashing.

A

The slip indicator light was on.

B

A

END

B
  1. CHECK DTCs AND FREEZE FRAME DATA

(a) Using the Techstream, check the DTCs and freeze frame data.

Click here

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

REPAIR THE CIRCUITS INDICATED BY THE OUTPUT DTCS

A
  1. PERFORM FUNCTION CHECK

(a) Make sure the ABS operates using a chassis dynamometer or equivalent.

CAUTION:

When using a chassis dynamometer, switch to check mode or VSC OFF mode and perform the check with TRAC and VSC disabled to prevent the vehicle from moving suddenly due to TRAC or VSC operation.

Click here

OK:

The ABS operates.

OK

END

NG

REPLACE BRAKE ACTUATOR ASSEMBLY