Brake Control / Dynamic Control Systems

ECU Mismatch (C1288)

~2min read

DESCRIPTION

The skid control ECU (brake actuator assembly) stores this DTC when the previously learned values in the engine stability control system and the engine information sent by the engine control module are inconsistent, or when learning is not complete after the skid control ECU (brake actuator assembly) has been replaced with a new one.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1288

ECU matching error

ECM mismatch.

ECM

PROCEDURE

  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check whether CAN communication system DTCs are output.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

INSPECT CAN COMMUNICATION SYSTEM

A
  1. PERFORM VEHICLE SYSTEM VARIANT LEARNING

(a) Perform system variant learning.

Click here

HINT:

  • System variant learning is performed automatically immediately after switching to Test Mode.
  • If learning has not yet been performed, the skid control warning light will remain on and DTC C1288 will be stored.
  • If system variant learning has not been performed correctly, the warning lights do not flash in Test Mode and DTC C1288 is not cleared.
NEXT
  1. CONFIRM DTC AGAIN

(a) Turn the ignition switch OFF.

(b) Clear the DTCs.

Click here

Chassis > ABS/VSC/TRAC/EPB > Clear DTCs

(c) Turn the ignition switch to OFF.

(d) Start the engine.

(e) Check whether the same DTC is output.

Click here

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

Result:

Result

Proceed to

DTC C1288 is not stored.

A

DTC C1288 is stored.

B

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

A

END

B

REPLACE ECM