Brake Control / Dynamic Control Systems

How to Use Troubleshooting

~2min read

PRECAUTION / NOTICE / HINT

HINT:

*: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS

(a) Ask the customer questions and confirm the problem.

Click here

NEXT
  1. CHECK DTCs AND FREEZE FRAME DATA*

(a) Check and record the DTCs and freeze frame data.

For DTC check / clear: Click here

For freeze frame data: Click here

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

(b) Clear the DTCs and freeze frame data.

For DTC check / clear: Click here

For freeze frame data: Click here

Chassis > ABS/VSC/TRAC/EPB > Clear DTCs

(c) Confirm the DTCs again.

(1) Confirm the DTCs again based on the freeze frame data and the recorded DTCs.

For DTC check / clear: Click here

For freeze frame data: Click here

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

HINT:

  • If CAN communication DTCs are output, repair the CAN communication system first.
  • If any of DTCs U0100, U0123, U0126 and/or U0142 are included in the output CAN communication DTCs, first use the Data List to check for a momentary open circuit.
  • If Techstream cannot communicate with the skid control ECU (brake actuator assembly), check the CAN communication system.
  • If there is no response from the skid control ECU (brake actuator assembly), check the +BS circuit of the skid control ECU (brake actuator assembly).

Result:

Result

Proceed to

DTCs are not output. (The problem symptom does not occur.)

A

DTCs are not output. (The problem symptom occurs.)

B

DTCs are output.

C

B

GO TO STEP 5

C

GO TO STEP 6

A
  1. SIMULATE SYMPTOMS

(a) Go to the How to Proceed with Troubleshooting section.

NEXT
  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Go to the Problem Symptoms Table.

Click here

NEXT

GO TO STEP 7

  1. DTC CHART

(a) Go to the Diagnostic Trouble Code Chart.

Click here

NEXT
  1. CIRCUIT INSPECTION*

NEXT
  1. PROBLEM SYMPTOMS TABLE

NEXT
  1. REPAIR OR REPLACEMENT

NEXT
  1. CONFIRMATION TEST*

NEXT

END