Brake Control / Dynamic Control Systems

Yaw Rate Sensor Malfunction (C1436)

~3min read

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) detects incorrect installation of the yaw rate and acceleration sensor (airbag sensor assembly), or an abnormality in the difference between the yaw rate sensor value and the estimated command value based on the signals from the acceleration sensor, steering angle sensor and speed sensor.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1436

Yaw Rate Sensor Malfunction

The difference between the yaw rate sensor value and the estimated command value inside the skid control ECU (brake actuator assembly) is not normal.

  • Sensor Installation
  • Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly)

PROCEDURE

  1. READ VALUE USING TECHSTREAM (YAW RATE AND ACCELERATION SENSOR)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Select the Data List using the Techstream.

Click here

Chassis > ABS/VSC/TRAC/EPB > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Yaw Rate Sensor

Yaw rate sensor

Min.: -128 °/s, Max.: 127 °/s

Vehicle stationary: 0 °/s

Turning right: -128 to 0°/s

Turning left: 0 to 127°/s

-

Chassis > ABS/VSC/TRAC/EPB > Data List

Yaw Rate Sensor

(d) Check the output value of the yaw rate and acceleration sensor (airbag sensor assembly) displayed on the Techstream.

Result:

Result

Proceed to

NG (The yaw rate and acceleration sensor (airbag sensor assembly) output value is 0 °/s when the vehicle is stopped, but the value fluctuates when turning.)

A

NG (The yaw rate and acceleration sensor (airbag sensor assembly) output value is not 0 °/s when the vehicle is stopped.)

B

OK

C

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

B

REPLACE AIRBAG SENSOR ASSEMBLY

C

USE SIMULATION METHOD TO CHECK

A
  1. CHECK STEERING ANGLE SENSOR NEUTRAL POINT CALIBRATION

(a) Turn the ignition switch OFF.

(b) Drive the vehicle in a straight line at 50 km/h or more for at least 30 seconds.

(c) Make sure the steering wheel is centered correctly while driving in a straight line.

HINT:

If front wheel alignment or steering wheel position adjustment must be performed due to steering wheel misalignment, obtain the yaw rate and acceleration sensor zero point again after the adjustments are completed.

OK:

The steering wheel is centered correctly.

NG

ADJUST FRONT WHEEL ALIGNMENT OR STEERING WHEEL

OK
  1. CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION

(a) Check that the yaw rate and acceleration sensor (airbag sensor assembly) is installed correctly.

Click here

OK:

The airbag sensor assembly is tightened to the specified torque.

The airbag sensor assembly is not installed in the correct (level) position.

HINT:

If troubleshooting was performed according to the symptom chart, refer to the chart and go to the next step before replacing parts.

Click here

OK

REPLACE AIRBAG SENSOR ASSEMBLY

NG

INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY