Trip Computer on the MID - Maximum speed

Entering the maximum speed:

You can control vehicle speed by entering a speed limit. When the set speed is reached, an audible signal will sound, the flashing message "LIMIT" will appear in the display, and the programmed speed limit will be shown on the alphanumeric display of the self-diagnostic system.

To allow the warning to sound again, reduce the speed by 5 km/h below the set limit.

Press the right edge of the button.

Press the button.

Press the right edge of the button.

Display:

Enter the speed limit by pressing the appropriate buttons.

To correct the entered value,

press the left edge of this button and enter the new value.

To save the entered value,

press the right edge of the button.

Setting the current speed as the limit:

Press the right edge of the button.

Press the button.

Press the right edge of the button twice.

Turning off the speed limit warning:

Press the right edge of the button.

Press the button.

The "LIMIT" message in the display goes out, but the value remains stored in memory. The warning function can be turned on again by pressing the "LIMIT" button.