Daewoo Nexia Quiz
Body

Headliner

In this manual: Body
OWNER'S MANUAL — 12Vehicle Maintenance — 15Maintenance — 16Engine (Single Overhead Camshaft) — 50Engine (dual overhead camshafts) — 45Cooling System — 14Fuel and Exhaust Systems — 31Engine Electrical Equipment — 16Ignition System — 8Electronic Control Unit and Sensors — 12Clutch — 11Five-Speed Transmission and Final Drive RPO MM5 — 16Automatic Transmission — 46Wheels and Tires — 17Front Suspension — 13Front Axle Drive Shafts — 10Rear Suspension — 12Brake System — 54Body — 127Heating, Ventilation and Air Conditioning System — 21Electrical System — 7Wiring Diagrams — 25
~2min read

Remove or disconnect:

PROCEDURE.

1. Disconnect the negative battery cable.

2. Remove the dome lamp lens and bulb.

3. Remove the 4 screws and the sun visors from the headliner.

4. Remove the 2 screws and the center sun visor brackets from the headliner.

sun visors..

5. Remove the plastic caps from the screws securing both rear grab handles.

6. Remove the 4 screws securing the rear grab handles.

7. Remove the rear grab handles by disconnecting the plastic clips.

8. Remove the door opening weatherstrips.

9. Remove the 2 screws and the B-pillar trim cover from the seat belt guide (sedan body).

10. Remove the upper interior trim panel of the rear side panel (hatchback body).

11. Remove the 1 screw and the A-pillar trim cover from the seat belt guide.

12. Remove the vent window frame holder (if equipped).

13. Remove the upper decorative rear door molding (hatchback body).

14. Remove the headliner from the vehicle.

Hatchback body vehicles – through the rear door opening.

Sedan body vehicles – through the right front door opening (under the trim panels). Install or connect

PROCEDURE.

1. Headliner into the vehicle interior.

Hatchback body vehicle – through the rear door opening.

Sedan body vehicle – through the right front door opening (under the trim panels).

2. Upper decorative rear door molding (hatchback body).

3. Vent window frame holder (if equipped).

4. Install the A-pillar trim cover onto the seat belt guide,

install one mounting screw.

5. Upper interior trim panel of the rear side panel (hatchback body).

6. Install the B-pillar trim cover onto the seat belt guide (sedan body) and install 2 mounting screws.

7. Door weatherstrip.

8. Install the rear grab handles onto the headliner.

9. Install 4 screws securing the rear grab handles.

10. Install the plastic caps on the screws securing the rear grab handles.

11. Install the sun visor center brackets, securing them with two

screws.

12. Sun visors to roof panel; secure each visor with two screws.

13. Lens and interior light bulb.

10. Negative battery cable.

Test yourself

A quick Daewoo Nexia quiz: every answer comes with an explanation and a link to the manual page.