Vent Hatch

GENERAL INFORMATION

Vent Sunroof

1. WASHER.

2. SCREW.

3. PLATE.

4. SPACER PLATE.

5. TAB.

6. HOLDER.

7. SCREW.

8. HINGE.

9. HINGE COVER.

10. FRAME HOLDER.

11. FRAME HOLDER.

12. RIVET.

13. HINGE.

14. SPACER PLATE.

15. SPACER PLATE.

16. HINGE LATCH.

17. HINGE.

18. RIVET.

19. HANDLE.

20. SPRING.

21. BUSHING.

22. PIN.

23. PIN.

24. CLAMP.

25. PIN.

26. HOLDER PLATE.

27. BUTTON HOLDER.

20. SPRING.

29. HOLDER.

30. TRIM.

31. NUT HOLDER.

32. SEALING GASKET.

33. FRAME.

34. FRAME HOLDER.

35. SEAL.

36. GLASS PANEL

The vent sunroof opens by pressing the latch handle forward and

locks in the open position by pressing the handle upward. One fixed open position is provided, with the rear edge raised 40 mm. The sunroof can be removed from the vehicle. To do this, first open the sunroof. Then press the two retainer tabs and lift the sunroof slightly so that

disconnect the front hinges..

To install the glass sunroof, perform the following operations.

Set the sunroof vertically with the front edge at the center of the seal. Align the hinges attached to the glass with

the corresponding slots in the roof opening. If a hinge becomes caught in the roof opening slot, repeat the installation. Insert the latch projection into the sunroof locking recess. Turn the latch handle down to fully lock the sunroof..

Using silicone grease extends the service life of the seal and improves its

sealing. Lubricate the seal once every six weeks..

Adjust the glass position to ensure reliable contact around the perimeter

of the seal is achieved by adding or removing latch device shims.