Rear Combination Lamp

GENERAL INFORMATION

Rear Combination Lamp

1. SCREW.

2. BRACKET.

3. LAMP ASSEMBLY

The rear combination lamps are secured to the body with screws. To replace

defective bulbs, remove the left or right cover (hatchback body) or the lower rear body trim panel (sedan). Then remove the bulbs to be replaced from the lamp housing.

Remove or disconnect:

PROCEDURE.

1. Disconnect the negative battery cable.

2. Remove the cover that provides access to the screws (hatchback body).

3. Remove the lower rear body trim panel (sedan).

4. Remove the 3 lamp mounting screws. Remove the lamp assembly from the body recesses and remove the brackets.

5. Disconnect the electrical connector.

6. Remove the combination lamp from the vehicle.

Installation

PROCEDURE.

1. Install the combination lamp on the vehicle. Connect the electrical connector.

2. Install the lamp brackets.

3. Install and tighten the mounting screws.

4. Install the lower rear body trim panel (sedan).

5. Install the cover that provides access to the screws (hatchback body).

6. Negative battery cable.