Glove Box Light
Components
COMPONENTS
ILLUSTRATION
*1 |
GLOVE BOX LIGHT ASSEMBLY |
*2 |
LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT GLOVE BOX LIGHT ASSEMBLY
*a |
Component without harness connected (Glove Box Light Assembly) |
(a) Apply auxiliary battery voltage to the glove box light assembly and check that the light illuminates.
OK:
Measurement Condition | Specified Condition |
|---|---|
Auxiliary battery positive (+) → 1 (B) Auxiliary battery negative (-) → 2 (L) |
Glove box light illuminates |
If the result is not as specified, replace the glove box light assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL GLOVE BOX LIGHT ASSEMBLY
(a) Turn the glove box light assembly as shown in the illustration to install it.
![]() |
Install in this Direction |
2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Click here ![]()
3. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during glove box light assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting system (for Gasoline Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting system (for HV Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
for Gasoline Model:
Click here ![]()
for HV Model:
Click here ![]()
PROCEDURE
1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here ![]()
2. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Click here ![]()
3. REMOVE GLOVE BOX LIGHT ASSEMBLY
(a) Turn the glove box light assembly as shown in the illustration to remove it.
![]() |
Remove in this Direction |


