Room Temperature Sensor
Components
COMPONENTS
ILLUSTRATION
*1 |
COOLER (ROOM TEMP. SENSOR) THERMISTOR |
*2 |
LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT COOLER (ROOM TEMP. SENSOR) THERMISTOR
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
NOTICE:
HINT: As the temperature increases, the resistance decreases (see the graph). If the result is not as specified, replace the cooler (room temp. sensor) thermistor. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL COOLER (ROOM TEMP. SENSOR) THERMISTOR
(a) Connect the connector and aspirator.
(b) Engage the 2 claws to install the cooler (room temp. sensor) thermistor as shown in the illustration.
![]() |
Install in this Direction |
2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cooler (room temp. sensor) thermistor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting system (for Gasoline Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here ![]()
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model) Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting system (for HV Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here ![]()
PROCEDURE
1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here ![]()
2. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR
![]() |
Remove in this Direction |
(a) Disengage the 2 claws as shown in the illustration.
(b) Disconnect the connector and aspirator to remove the cooler (room temp. sensor) thermistor. |
![]() |




