Power Seat Control Ecu
Components
COMPONENTS
ILLUSTRATION
*1 |
POSITION CONTROL ECU ASSEMBLY LH |
- |
- |
Installation
INSTALLATION
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. INSTALL POSITION CONTROL ECU ASSEMBLY LH
(a) Install the position control ECU assembly LH with the 3 screws. |
![]() |
(b) Connect the 3 connectors. |
![]() |
(c) Engage the 2 clamps.
2. INSTALL FRONT SEAT ASSEMBLY LH
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly LH removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting system (for Gasoline Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
|
Initialize position control ECU |
Front power seat control system |
|
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting system (for HV Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
|
Initialize position control ECU |
Front power seat control system |
|
CAUTION:
- Be sure to read Precaution thoroughly before servicing.
for Gasoline Model: Click here

for HV Model: Click here

- Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY LH
Click here ![]()
2. REMOVE POSITION CONTROL ECU ASSEMBLY LH
(a) Disengage the 2 clamps. |
![]() |
(b) Disconnect the 3 connectors.
(c) Remove the 3 screws and position control ECU assembly LH. |
![]() |



