Vehicle Interior
Relay
In this manual: Vehicle Interior
~1min read
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT MG CLT RELAY (for 2GR-FKS)
*a |
MG CLT Relay |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
3 - 5 |
Battery voltage applied between terminal 1 and 2 |
Below 1 О© |
3 - 5 |
Battery voltage not applied between terminal 1 and 2 |
10 kО© or higher |
If the result is not as specified, replace the MG CLT relay.
2. INSPECT PTC HEATER RELAY (for A25A-FXS)
*a |
PTC Heater Relay |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
3 - 5 |
Auxiliary battery voltage applied between terminal 1 and 2 |
Below 1 О© |
3 - 5 |
Auxiliary battery voltage not applied between terminal 1 and 2 |
10 kО© or higher |
- If the result is not as specified, replace the PTC heater relay.
Was this page helpful?