Engine Coolant Temperature Sensor
Components
COMPONENTS
ILLUSTRATION
*1 |
AIR CLEANER CAP WITH AIR CLEANER HOSE |
*2 |
ENGINE COOLANT TEMPERATURE SENSOR |
*3 |
VACUUM HOSE |
*4 |
NO. 1 FUEL VAPOR FEED HOSE |
*5 |
NO. 2 VENTILATION HOSE |
- |
- |
Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
CAUTION:
- Do not put your hands into the water that has been heated for the inspection.
- Touching the heated water could result in burns.
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
NOTICE: If checking the engine coolant temperature sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the engine coolant temperature sensor. If the result is not as specified, replace the engine coolant temperature sensor. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here ![]()
(a) Apply a light coat of engine coolant to the O-ring of the engine coolant temperature sensor.
NOTICE:
If reusing the engine coolant temperature sensor, be sure to inspect the O-ring.
(b) Install the engine coolant temperature sensor to the water outlet with the clip.
NOTICE:
- If the engine coolant temperature sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the engine coolant temperature sensor.
(c) Connect the engine coolant temperature sensor connector.
2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
Click here ![]()
3. ADD ENGINE COOLANT
Click here ![]()
4. INSPECT FOR COOLANT LEAK
Click here ![]()
5. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
Replacement of engine coolant temperature sensor |
Inspection after repair |
|
PROCEDURE
1. DRAIN ENGINE COOLANT
Click here ![]()
2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
Click here ![]()
3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR
(a) Disconnect the engine coolant temperature sensor connector. |
![]() |
(b) Remove the clip and engine coolant temperature sensor from the water outlet. NOTICE: If the engine coolant temperature sensor has been struck or dropped, replace it. |
![]() |



