Pcv Valve
Components
COMPONENTS
ILLUSTRATION
*1 |
PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY) |
- |
- |
Inspection
INSPECTION
PROCEDURE
1. INSPECT PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
(a) Install a hose to the PCV valve (ventilation valve sub-assembly).
(b) Check the PCV valve (ventilation valve sub-assembly) operation.
(1) Blow air into the cylinder head sub-assembly side, and check that air passes through easily.
*a |
Hose |
*b |
Air |
![]() |
Cylinder Head Sub-assembly Side |
CAUTION:
Do not suck air through the valve.
Petroleum substances inside the valve are hazardous to your health.
If the result is not as specified, replace the PCV valve (ventilation valve sub-assembly).
(2) Blow air into the intake manifold side, and check that air passes through with difficulty.
*a |
Hose |
*b |
Air |
![]() |
Intake Manifold Side |
CAUTION:
Do not suck air through the valve.
Petroleum substances inside the valve are hazardous to your health.
If the result is not as specified, replace the PCV valve (ventilation valve sub-assembly).
(c) Remove the hose from the PCV valve (ventilation valve sub-assembly).
Installation
INSTALLATION
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here ![]()
PROCEDURE
1. INSTALL PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
(a) Apply a light coat of engine oil to the O-ring.
NOTICE:
When reusing the PCV valve (ventilation valve sub-assembly), inspect the O-ring.
(b) Install the PCV valve (ventilation valve sub-assembly) to the cylinder head sub-assembly.
2. INSTALL INTAKE MANIFOLD
Click here ![]()
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Put the engine in Inspection Mode (Maintenance Mode).
Powertrain > Hybrid Control > UtilityInspection Mode
(e) Check the PCV valve (ventilation valve sub-assembly) operation. (1) Start the engine. (2) Slide the clip and disconnect the No. 2 ventilation hose from the air cleaner hose assembly. (3) Check that air is sucked into the No. 2 ventilation hose. Standard: Air is sucked into the No. 2 ventilation hose. If the result is not as specified, replace the PCV valve (ventilation valve sub-assembly). |
![]() |
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during PCV valve (ventilation valve sub-assembly) removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedures | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection After Repair |
|
NOTICE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here ![]()
PROCEDURE
1. REMOVE INTAKE MANIFOLD
Click here ![]()
2. REMOVE PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
(a) Remove the PCV valve (ventilation valve sub-assembly) from the cylinder head sub-assembly. |
![]() |



