Fuel Filter
Components
COMPONENTS
ILLUSTRATION
*A |
Type A |
*B |
Type B |
*1 |
FUEL PUMP |
*2 |
FUEL SUCTION PLATE SUB-ASSEMBLY |
*3 |
FUEL SENDER GAUGE ASSEMBLY |
*4 |
FUEL FILTER |
*5 |
FUEL MAIN VALVE ASSEMBLY (for Low Pressure) |
*6 |
FUEL MAIN VALVE ASSEMBLY (for High Pressure) |
*7 |
NO. 1 FUEL SUCTION SUPPORT |
*8 |
FUEL PUMP HARNESS |
*9 |
O-RING |
*10 |
FUEL PUMP SPACER |
*11 |
FUEL SUB-TANK |
*12 |
HARNESS PROTECTOR |
*13 |
SUCTION FILTER |
- |
- |
● |
Non-reusable part |
- |
- |
Replacement
REPLACEMENT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel filter removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane Departure Alert System (w/ Steering Control) |
|
Pre-collision System |
|||
Intelligent Clearance Sonar System* |
|||
Lighting System (for Gasoline Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking Assist Monitor System |
||
Panoramic View Monitor System |
|||
Replacement of fuel pump |
Inspection after repair |
|
|
CAUTION:
- Never perform work on fuel system components near any possible ignition sources.

- Vaporized fuel could ignite, resulting in a serious accident.
- Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

- Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
PROCEDURE
1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Click here ![]()
2. REMOVE FUEL SENDER GAUGE ASSEMBLY
Click here ![]()
3. REMOVE FUEL PUMP
Click here ![]()
4. REMOVE FUEL MAIN VALVE ASSEMBLY
Click here ![]()
5. REMOVE NO. 1 FUEL SUCTION SUPPORT
(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter. |
|
6. INSTALL NO. 1 FUEL SUCTION SUPPORT
(a) Engage the 2 claws to install the No. 1 fuel suction support to the fuel filter.
7. INSTALL FUEL MAIN VALVE ASSEMBLY
Click here ![]()
8. INSTALL FUEL PUMP
Click here ![]()
9. INSTALL FUEL SENDER GAUGE ASSEMBLY
Click here ![]()
10. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Click here ![]()

