Water Pump
Components
COMPONENTS
ILLUSTRATION
*1 |
ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING) |
*2 |
GASKET |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
Installation
INSTALLATION
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here ![]()
PROCEDURE
1. INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
(a) Install a new gasket to the engine water pump assembly (water inlet housing).
HINT:
Be sure to clean the contact surfaces.
(b) Install the engine water pump assembly (water inlet housing) to the cylinder block assembly with the 4 bolts.
Torque:
43 N·m {438 kgf·cm, 32 ft·lbf}
(c) Connect the engine water pump assembly (water inlet housing) connector.
(d) Align the protrusion of the engine water pump assembly (water inlet housing) with the cutout in the sensor wire clamp. |
|
(e) Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(f) Connect the sensor wire connector.
2. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Click here ![]()
3. INSTALL INTAKE MANIFOLD
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly (water inlet housing) removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection After Repair |
|
NOTICE:
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here ![]()
PROCEDURE
1. REMOVE INTAKE MANIFOLD
Click here ![]()
2. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Click here ![]()
3. REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
(a) Disconnect the sensor wire connector. |
![]() |
(b) Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing). |
![]() |
(c) Disconnect the engine water pump assembly (water inlet housing) connector. |
![]() |
(d) Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly. |
![]() |
(e) Remove the gasket from the engine water pump assembly (water inlet housing). |
![]() |







