Hybrid Vehicle Control Ecu
Components
COMPONENTS
ILLUSTRATION
*1 |
HYBRID VEHICLE CONTROL ECU |
*2 |
NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL HYBRID VEHICLE CONTROL ECU
(a) Install the hybrid vehicle control ECU with the bolt and nut.
Torque:
Bolt :
8 N·m {82 kgf·cm, 71 in·lbf}
Nut :
5,5 N·m {56 kgf·cm, 49 in·lbf}
(b) Connect the 4 hybrid vehicle control ECU connectors.
2. INSTALL NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
Click here ![]()
3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. | |||
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting System (for HV Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
Replacement of hybrid vehicle control ECU |
Code registration (Smart key System (for Start Function)) |
|
|
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here ![]()
NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click here ![]()
PROCEDURE
1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here ![]()
2. REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
Click here ![]()
3. REMOVE HYBRID VEHICLE CONTROL ECU
(a) Disconnect the 4 hybrid vehicle control ECU connectors. |
![]() |
(b) Remove the bolt, nut and hybrid vehicle control ECU. |
![]() |



