Water Pump With Motor
Components
COMPONENTS
ILLUSTRATION
*1 |
NO. 1 ENGINE UNDER COVER |
*2 |
FRONT WHEEL OPENING EXTENSION PAD LH |
*3 |
FRONT WHEEL OPENING EXTENSION PAD RH |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*1 |
INVERTER WATER PUMP ASSEMBLY |
*2 |
NO. 2 INVERTER COOLING HOSE |
*3 |
NO. 3 INVERTER COOLING HOSE |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL INVERTER WATER PUMP ASSEMBLY
(a) Connect the No. 2 inverter cooling hose and No. 3 inverter cooling hose to the inverter water pump assembly and slide the 2 clips to secure them. NOTICE:
HINT:
|
|
(b) Temporarily install the inverter water pump assembly to the fan shroud assembly with the 2 bolts.
(c) Fully tighten the 2 bolts.
Torque:
7 N·m {71 kgf·cm, 62 in·lbf}
NOTICE:
As overtightening the bolts may damage the fan shroud assembly, make sure to use a torque wrench.
(d) Connect the inverter water pump assembly connector.
NOTICE:
If a dustproof cap is installed to the inverter water pump assembly connector, do not remove it until the connector is to be connected.
2. ADD COOLANT (for Inverter)
Click here ![]()
3. INSPECT FOR COOLANT LEAK (for Inverter)
Click here ![]()
4. INSTALL NO. 1 ENGINE UNDER COVER
Click here ![]()
5. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Click here ![]()
6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Click here ![]()
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Click here ![]()
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here ![]()
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here ![]()
4. DRAIN COOLANT (for Inverter)
Click here ![]()
5. REMOVE INVERTER WATER PUMP ASSEMBLY
(a) Disconnect the inverter water pump assembly connector. To prevent coolant from entering the inverter water pump assembly connector, perform the following procedure.NOTICE: Apply insulating tape to the connectors of the wire harness and inverter water pump assembly. |
![]() |
(b) Remove the 2 bolts to remove the inverter water pump assembly from the fan shroud assembly.
(c) Slide the 2 clips and disconnect the No. 2 inverter cooling hose and No. 3 inverter cooling hose to remove the inverter water pump assembly. NOTICE:
|
|



