Ignition Coil And Spark Plug
Components
COMPONENTS
ILLUSTRATION
*1 |
IGNITION COIL ASSEMBLY |
*2 |
SPARK PLUG |
*3 |
V-BANK COVER SUB-ASSEMBLY |
*4 |
VACUUM HOSE |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL SPARK PLUG
Click here ![]()
2. INSTALL IGNITION COIL ASSEMBLY
HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly.
Click here ![]()
(a) Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly with the 3 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
(b) Connect the 3 ignition coil assembly connectors.
(c) Engage the 2 wire harness clamps.
(d) Engage the 4 clamps to install the vacuum hose to the intake air surge tank assembly.
(e) Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly LH with the 3 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
(f) Connect the 3 ignition coil assembly connectors.
3. INSTALL V-BANK COVER SUB-ASSEMBLY
Click here ![]()
4. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection after repair |
|
PROCEDURE
1. REMOVE V-BANK COVER SUB-ASSEMBLY
Click here ![]()
2. REMOVE IGNITION COIL ASSEMBLY
(a) Disconnect the 3 ignition coil assembly connectors. |
![]() |
(b) Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly LH.
NOTICE:
If an ignition coil assembly has been struck or dropped, replace it.
HINT:
Arrange the removed parts in the correct order.
(c) Disengage the 4 clamps to separate the vacuum hose from the intake air surge tank assembly. |
![]() |
(d) Disengage the 2 wire harness clamps.
(e) Disconnect the 3 ignition coil assembly connectors.
(f) Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly. NOTICE: If an ignition coil assembly has been struck or dropped, replace it. HINT: Arrange the removed parts in the correct order. |
![]() |
3. REMOVE SPARK PLUG
Click here ![]()




