Nissan Sunny Quiz
Fuel and Exhaust System

Throttle position sensor

In this manual: Fuel and Exhaust System
Owner's Manual — 35Maintenance — 752.0 Liter Gasoline Engine — 36Diesel Engine — 32Cooling System — 11Heating and Ventilation System — 10Fuel and Exhaust System — 154Engine Starting System — 16Clutch — 7Manual transmission — 7Automatic transmission — 9Axle Shafts — 7Brakes — 22Suspension and Steering — 52Electrical System — 30
~1min read

Removal

PROCEDURE

1. Потенциометр дроссельной заслонки (указан стрелкой) установлен на правой стороне

1. The throttle position sensor (indicated by the arrow) is installed on the right side of the throttle body. Before removing it, disconnect the negative battery cable.

2. Disconnect the throttle position sensor connector.

3. Using white paint or a marker, make alignment marks on the throttle body and the throttle position sensor.

4. Remove the two mounting screws and remove the throttle position sensor.

5. During installation, position the throttle position sensor on the throttle body so that its lever is correctly engaged with the throttle shaft lever.

6. Install the mounting plate, then align the marks made before removal and loosely tighten the mounting screws. Adjust the throttle position sensor as follows.

7. Using a tester set to measure resistance, check that the throttle position sensor resistance is as specified in the Specifications section (refer to subsection 6.3.2.1). If necessary, loosen the mounting screws and rotate the throttle position sensor so that its resistance is as specified in the Specifications section.

8. When the throttle position sensor is correctly installed, securely tighten the mounting screws and connect the connector.

9. Connect the negative battery cable.

Test yourself

A quick Nissan Sunny quiz: every answer comes with an explanation and a link to the manual page.