Throttle Cable

Removal

PROCEDURE

1. Disconnect the cable from the cam on the carburetor.

2. Unscrew the cable housing nuts from the bracket and remove the cable housing from the bracket (the arrows indicate the throttle cable adjusting nuts).

3. Free the cable along its entire routing.

4. Inside the cabin, remove the lower panel on the driver's side.

5. Disconnect the cable from the pedal.

6. Unscrew the nuts securing the housing to the engine compartment bulkhead and pull out the cable, feeding it into the engine compartment.

Installation

PROCEDURE

1. Pass the cable through the engine compartment bulkhead.

2. Feed the cable into the engine compartment and route it into position.

3. Secure the cable housing to the engine compartment bulkhead with nuts.

4. Connect the cable to the pedal.

5. Install the lower panel.

6. Secure the cable housing along its entire routing.

7. Connect the cable to the cam on the throttle shaft.

8. Adjust the cable.

Adjustment

PROCEDURE

1. Loosen the adjusting nuts and make sure the cam rests against the stop.

2. Tighten the far nut. As soon as the cam starts to move, loosen the nut by 1.5–2 turns and tighten the locknut.

3. Have an assistant press the pedal and check that the cam moves smoothly.