Solenoid Valve

GENERAL INFORMATION

Replacement of the Electronic Fuel Injection Control Solenoid Valve – models with electronic fuel injection (except "Phase I" models with 2.0 liter engine and multi-point fuel injection system).

Solenoid valve on "Phase II" models with 2 L engine The solenoid valve is installed on the main mounting bracket of the intake manifold.

The control solenoid valve is installed on the rear side of the intake manifold on models with 1.6 liter engine, and on the left or lower side of the intake manifold on models with 2.0 liter engine.

To improve access to the solenoid valve on models with 1.6 liter engine, remove the air cleaner cover. On models with 2.0 liter engine, raise the front of the vehicle and support it on stands to access the valve from under the vehicle (if necessary).

Replacement

PROCEDURE

1. To replace the solenoid valve, disconnect the negative battery cable, then squeeze the retaining clip and disconnect the valve connector.

2. Note or mark the installation position of all hoses on the valve. To avoid connecting the hoses incorrectly during installation, mark each hose and fitting during removal.

3. Release the clamps (if equipped) and disconnect the hoses from the valve, then remove the valve from the mounting bracket.

4. Installation is the reverse of removal. When installing, check that the hoses are connected correctly.