Brake Control System - Automatic Emergency Braking
- Precautions
- Wiring Diagram. Automatic Emergency Braking System
Precautions Nissan Pathfinder
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.
Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.
Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.
Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.
Precaution for AEB System Service
The vehicles brake lights come on when any braking is performed by the AEB with pedestrian detection system. Depending on Nissan Pathfinder vehicle speed and distance to the vehicle or pedestrian ahead, as well as driving and roadway conditions, the system may help the driver avoid a forward collision or may help mitigate the consequences if a collision should be unavoidable. If the driver is handling the steering wheel, accelerating or braking, the AEB with pedestrian detection system will function later or not function.
The automatic braking will cease under the following conditions:
When the steering wheel is turned to avoid a collision.
When the accelerator pedal is depressed.
When there is no longer a Nissan Pathfinder vehicle or pedestrian detected ahead.
If the AEB with pedestrian detection system has stopped the Nissan Pathfinder vehicle, the vehicle will remain at a standstill for approximately 2 seconds before the brakes are released.
The AEB with pedestrian detection system will be automatically turned on when the engine is started.
The I-FCW system (if equipped) is integrated into the AEB with pedestrian detection system. There is not a separate selection in the Nissan Pathfinder vehicle information display for the I-FCW system. When the AEB with pedestrian detection is turned off, the I-FCW system is also turned off.
Precaution for Harness Repair
Solder the repaired area and wrap tape around the soldered area.

Bypass connection is never allowed at the repaired area.

Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.
Wiring Diagram. Automatic Emergency Braking System Nissan Pathfinder 5th Gen
Wiring Diagram
Refer to Wiring Diagram.