Engine Lubrication System - Periodic Maintenance
- Engine Oil
- Oil Filter
Engine Oil Nissan Pathfinder R53
Inspection
ENGINE OIL LEVEL
Remove oil level gauge and wipe it clean.
Insert oil level gauge and check that the engine oil level is within the range (A) shown.

If engine oil level is out of range, add oil as necessary until oil level gauge indicates the correct level.
ENGINE OIL APPEARANCE
Check engine oil for white milky appearance or excessive contamination.
If engine oil becomes milky, it is highly probable that it is contaminated with engine coolant. Repair or replace damaged parts.
ENGINE OIL LEAKS
Check for engine oil leaks around the following areas:
Oil pan (upper)
Oil pan (lower)
Oil pan drain plug
Engine oil pressure sensor
Engine oil temperature sensor
Oil filter
Oil cooler
Valve timing control cover
Exhaust valve timing control solenoid valve
Front timing chain case
Mating surface between rear timing chain case and cylinder head
Mating surface between rear timing chain case and cylinder block
Mating surface between rear timing chain case and oil pan (upper)
Mating surface between rear timing chain case and front timing chain case
Mating surface between cylinder block and cylinder head
Mating surface between cylinder head and rocker cover
Crank oil seal (front and rear)
Engine oil pressure control solenoid valve
Camshaft position sensor
Exhaust camshaft position sensor
Intake camshaft position sensor
High pressure fuel pump
Draining
Prolonged and repeated contact with used engine oil may cause skin cancer; try to avoid direct skin contact with used engine oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
Position the vehicle so it is level on the hoist.
Warm up the engine and check for engine oil leaks. Refer to Inspection.
Stop engine and wait for 10 minutes.
Remove the front under cover. Refer to Removal and Installation.
Loosen oil filler cap.
Remove the oil pan drain plug and drain the engine oil.
Refilling
Install drain plug with new drain plug washer.
| Tightening torque | : Refer to Exploded View. |
Refill with new engine oil.
| Engine oil specification and capacity | : Refer to Fluids and Lubricants. |
Warm up engine and check area around drain plug and oil filter for engine oil leaks.
Install front under cover. Refer to Removal and Installation.
Stop engine and wait 10 minutes.
Check engine oil level. Refer to Inspection.
Oil Filter Nissan Pathfinder Fifth generation
Removal and Installation
REMOVAL
Drain engine oil. Refer to Draining.
Remove front fender protector side cover (RH). Refer to Exploded View.
Remove the oil filter using suitable tool.
INSTALLATION
Remove foreign materials adhering to the oil filter installation surface.
Apply clean engine oil to the oil seal contact surface of the new oil filter.

Screw the oil filter manually until it touches the installation surface, then tighten it by turning another 2/3 turn (A), or tighten to specification using a suitable tool.

| Oil filter | : 18 N·m |
Refill the engine with new engine oil. Refer to Refilling.
Check the oil level and add engine oil as necessary. Refer to Inspection.
After warming up the engine, check for engine oil leaks.
Install front fender protector side cover (RH). Refer to Exploded View.