In this manual: Srs Air Bag - Removal and Installation
4steps
~24min
5/5difficulty
Tightening torque found on this page
Done 0 of 4
Driver Air Bag Module
Spiral Cable
Front Passenger Air Bag Module
Knee Air Bag Module Lh
Side Curtain Air Bag Module
Front Side Air Bag Module
Rear Side Air Bag Module
Crash Zone Sensor
Front Door Satellite Sensor
Rear Side Air Bag Satellite Sensor
Air Bag Diagnosis Sensor Unit
Front Seat Belt Pre-Tensioner
Rear Seat Belt Pre-Tensioner
Front Seat Belt Buckle Switch
Front Passenger Air Bag Off Indicator
Driver Air Bag Module Nissan Pathfinder 2026
Exploded View
1.
Steering wheel
2.
Driver air bag module
Removal and Installation
REMOVAL
Disconnect negative battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Locate the access holes.
(A)
: Right side access hole
(B)
: Left side access hole
(C)
: Bottom access hole
On the left side, right side, and bottom access holes of the steering wheel, check the position of the torsion spring (A) securing the driver air bag module.
: Front
Insert suitable tool (A) into the left side access hole, then press and disengage torsion spring (B).
: Front
Disengage the remaining springs on the right side and bottom access hole.
Disconnect harness connector (A) from the driver air bag module and harness connector (B) from the horn switch.
Remove the driver air bag module harnesses (A) from the hook (B) and remove the driver air bag module.
INSTALLATION
Make sure the driver air bag module harnesses (A) is positioned through the hook (B) of the steering wheel as shown.
Connect the harness connectors (A) to the driver air bag module and harness connector (B) to the horn switch.
Make sure the driver air bag module harnesses (A) are positioned through the hook (B) of the driver air bag module.
Install the driver air bag module (1) to the steering wheel.
: Metal clip
Connect the negative and positive battery terminals. Refer to Battery Disconnect.
Check the horn and each function of the steering switches.
Check that no system malfunction is detected causing the air bag warning lamp to illuminate.
Spiral Cable Nissan Pathfinder 5th Gen
Exploded View
1.
Combination switch
2.
Steering angle sensor
3.
Spiral cable
Pawl
Removal and Installation
REMOVAL
Disconnect negative battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the steering wheel. Refer to Removal and Installation.
Remove the steering column upper and lower covers. Refer to Removal and Installation.
Disconnect harness connectors (A) from the spiral cable (1).
Disconnect the harness connector (B) from the steering angle sensor (2).
Using suitable tool, release pawls and remove spiral cable with steering angle sensor from the combination switch.
: Pawl
Using suitable tool, release pawls and remove the steering angle sensor (1) from the spiral cable (2).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
The turn signal lever must be in the neutral position for spiral cable installation.
When installing the steering angle sensor to the spiral cable, make sure the spiral cable notch (A) is aligned with notch (B) of the steering angle sensor.
Set the spiral cable neutral position by carefully turning the spiral cable clockwise to the end position. Turn the spiral cable counterclockwise 2.5 turns stopping when the locating pin (A) is at the top most position and the clear window (B) appears yellow.
During steering wheel installation, make sure the spiral cable locating pin (A) is aligned with slot (B) on back of steering wheel.
Perform the neutral position adjustment for the steering angle sensor. Refer to Description.
Front Passenger Air Bag Module Nissan Pathfinder Fifth generation
Exploded View
1.
Instrument panel assembly
2.
Front passenger air bag module
3.
Steering member assembly
Removal and Installation
REMOVAL
Disconnect negative terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the instrument panel assembly. Refer to Removal and Installation.
Remove the harness attachments from the instrument panel assembly.
Remove the front passenger air bag module screws.
Remove the front passenger air bag module (1) from the instrument panel assembly in the order shown.
INSTALLATION
Installation is in the reverse order of removal.
Knee Air Bag Module Lh Nissan Pathfinder Fifth generation
Exploded View
1.
Knee air bag module LH
Removal and Installation
Removal
Disconnect negative battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the instrument lower panel LH. Refer to Removal and Installation.
Remove the bolts from the knee air bag module LH. Refer to Exploded View.
Disconnect the harness connector and release harness retainer from the knee air bag module LH.
Remove knee air bag module LH.
INSTALLATION
Installation is in the reverse order of removal.
When installing the knee air bag module LH, hand-tighten the bolts first before tightening to specification.
Side Curtain Air Bag Module Nissan Pathfinder 5th Gen
Exploded View
1.
Side curtain air bag module
A.
Refer to Removal and Installation.
Pawl
Removal and Installation
REMOVAL
Disconnect negative battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the rear ventilator duct upper. Refer to Removal and Installation (RH) or Removal and Installation (LH).
Disconnect the harness connector and release harness retainer from the side curtain air bag module.
Remove the side curtain air bag module bolts, then remove the side curtain air bag module from the body slots in the order shown.
: Front
INSTALLATION
Install the side curtain air bag module in numerical order, using the following steps.
: Front
Step 1
: No. 1 - 2
Install supporting hooks
Step 2
: No. 1 - 2
10,8 N·m
Step 3
: No. 3 - 14
Install supporting hooks
Step 4
: No. 3 - 14
10,8 N·m
Step 5
: No. 15
Install supporting hook
Step 6
: No. 15
10,8 N·m
Connect the harness connector to the side curtain air bag module.
Installation of the remaining components is in the reverse order of removal.
Front Side Air Bag Module Nissan Pathfinder 2022
Exploded View
For exploded view of the front side air bag module. Refer to Exploded View.
Removal and Installation
For removal and installation of the front side air bag module. Refer to Seatback.
Rear Side Air Bag Module Nissan Pathfinder 2026
Exploded View
For exploded view of the rear side air bag module. Refer to Exploded View.
Removal and Installation
REMOVAL
Remove the second row seat cushion. Refer to Seat Cushion (Seat RH), Seat Cushion (Captain seat LH), or Seat Cushion (Bench seat LH).
Remove the second row seatback. Refer to Seatback (Seat RH), Seatback (Captain seat LH), or Seatback (Bench seat LH).
Remove screws (A) and remove the seat cushion inner finisher (1) to access the rear side air bag module harness.
Using a suitable tool, release the rear side air bag module harness retainers from the seat frame assembly.
Remove the rear side air bag module.
INSTALLATION
Installation is in the reverse order of removal.
Make sure the recline release cable assembly strap (A) is routed through the seat cushion inner finisher (1).
Crash Zone Sensor Nissan Pathfinder Fifth generation
Exploded View
1.
Crash zone sensor
Front
Removal and Installation
REMOVAL
Disconnect negative battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the front air duct. Refer to Removal and Installation.
Disconnect the harness connector from the crash zone sensor.
Remove the crash zone sensor bolt.
Remove the crash zone sensor.
INSTALLATION
Installation is in the reverse order of removal.
Front Door Satellite Sensor Nissan Pathfinder 2022
Exploded View
1.
Front door air bag satellite sensor
Front
Removal and Installation
REMOVAL
Disconnect negative battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the front door finisher. Refer to Removal and Installation.
Remove the front door vapor barrier (1) to access the front door satellite sensor.
Disconnect the harness connector from the front door satellite sensor.
While pushing the lock pin, rotate the front door satellite sensor counter-clockwise in the direction shown and remove.
INSTALLATION
Position the front door satellite sensor on the door with the connector surface in the 5 O’clock position.
Rotate the front door satellite sensor clockwise.
Connect the harness connector to the front door satellite sensor.
Installation of the remaining components is in the reverse order of removal.
Rear Side Air Bag Satellite Sensor Nissan Pathfinder Fifth generation
Exploded View
1.
Rear side air bag satellite sensor
Front
Removal and Installation
REMOVAL
Disconnect negative battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the luggage side lower finisher. Refer to Removal and Installation.
Remove the rear side air bag satellite sensor bolt.
Disconnect the harness connector from the rear side air bag satellite sensor.
Remove the rear side air bag satellite sensor.
INSTALLATION
Installation is in the reverse order of removal.
Position the rear side air bag satellite sensor using the pawl before tightening the bolt to specification.
Air Bag Diagnosis Sensor Unit Nissan Pathfinder 2022
Exploded View
1.
Air bag diagnosis sensor unit
Front
Removal and Installation
REMOVAL
Always check the air bag diagnosis sensor unit ECU discriminated number (identification number) or part number using CONSULT.
Disconnect negative and positive battery terminals, then wait at least three minutes. Refer to Battery Disconnect.
Remove the center console assembly. Refer to Removal and Installation.
Remove the air bag diagnosis sensor unit nuts and bolt.
Disconnect the harness connectors from the air bag diagnosis sensor unit and remove.
INSTALLATION
Installation is in the reverse order of removal.
Front Seat Belt Pre-Tensioner Nissan Pathfinder
Removal and Installation
The front seat belt pre-tensioner is serviced as part of the front seat belt retractor. For removal and installation of the front seat belt retractor, refer to Removal and Installation (for USA and Canada) or Removal and Installation (for Mexico).
Rear Seat Belt Pre-Tensioner Nissan Pathfinder Fifth generation
Removal and Installation
The rear seat belt pre-tensioner is serviced as part of the second row seat belt retractor. For removal and installation of the second row seat belt retractor, refer to Removal and Installation.
Front Seat Belt Buckle Switch Nissan Pathfinder 2022
Removal and Installation
The front seat belt buckle switch is serviced as part of the front seat belt buckle. For removal and installation of the front seat belt buckle, refer to Removal and Installation.
Front Passenger Air Bag Off Indicator Nissan Pathfinder R53
Removal and Installation
REMOVAL
Using suitable tool, release clips and remove windshield glass finisher (1).
: Front
: Clip
Remove screws (A) and remove the front passenger air bag OFF indicator (1) from the windshield glass finisher (2).