Engine Control System - Removal and Installation
- Ecm
- Stop/start Off Switch
- Electric Intake Valve Timing Control Module
- Fuel Pump Control Module (fpcm)
Ecm Nissan Pathfinder 2022
Exploded View

| 1. | ECM | 2. | ECM bracket | Front |
Removal and Installation
REMOVAL
Remove battery tray. Refer to Removal and Installation.
Disconnect the harness connector from ECM.
Remove ECM nuts, and then remove ECM.
If necessary, remove bolts and then the ECM bracket.
INSTALLATION
Installation is in the reverse order of removal.
Stop/start Off Switch Nissan Pathfinder 5th Gen
Removal and Installation
Disconnect the negative terminal from the battery. Refer to Battery Disconnect.
Remove shift selector finisher. Refer to Exploded View.
Disconnect the harness connectors from the switches on the shift selector finisher.
Remove the screws (A).

Remove the stop/start off switch (1) from shift selector finisher (2).
INSTALLATION
Installation is in the reverse order of removal.
Electric Intake Valve Timing Control Module Nissan Pathfinder
Exploded View

| 1. | Electric intake valve timing control module bracket | 2. | Electric intake valve timing control module | Front |
Removal and Installation
REMOVAL
Disconnect the battery negative terminal. Refer to Battery Disconnect.
Remove wheel and tire (LH). Refer to Removal and Installation.
Partially remove front half of fender protector (LH). Refer to Removal and Installation.
Disconnect harness connector from electric intake valve timing control module.
Remove electric intake valve timing control module.
If necessary, remove electric intake valve timing control module bracket.
INSTALLATION
Installation is in the reverse order of removal.
Fuel Pump Control Module (fpcm) Nissan Pathfinder Fifth generation
Exploded View

| 1. | Fuel pump control module | 2. | Fuel pump control module bracket | Front |
Removal and Installation
REMOVAL
Disconnect the battery negative terminal. Refer to Battery Disconnect.
Remove luggage side lower finisher (LH). Refer to Removal and Installation.
Disconnect harness connector from fuel pump control module.
Remove nut and bolt from bracket and remove fuel pump control module assembly.
If necessary, remove bolts from fuel pump control module and remove fuel pump control module bracket.
INSTALLATION
Installation is in the reverse order of removal.