Drive Mode System - Drive Mode Select Switch Circuit
Diagnosis Procedure
CHECK DRIVE MODE SELECT SWITCH SIGNAL CIRCUIT
Ignition switch OFF.
Disconnect drive mode select switch harness connector and BCM harness connector.
Check the continuity between drive mode select switch harness connector and BCM harness connector.
2WD models Drive mode select switch BCM Continuity Connector Terminal Connector Terminal M223 2 M19 80 Existed 6 57 4WD models Drive mode select switch BCM Continuity Connector Terminal Connector Terminal M229 3 M18 25 Existed Also check harness for short to ground and to power.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair / replace harness or connector.
CHECK DRIVE MODE SELECT SWITCH GROUND CIRCUIT
Check the continuity between drive mode select switch harness connector and ground.
| Drive mode select switch | – | Continuity | |
|---|---|---|---|
| Connector | Terminal | ||
| M223 | 1 | Ground | Existed |
| Drive mode select switch | – | Continuity | |
|---|---|---|---|
| Connector | Terminal | ||
| M229 | 4 | Ground | Existed |
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair / replace harness or connector.
CHECK DRIVE MODE SELECT SWITCH
Check drive mode select switch. Refer to Removal and Installation.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace drive mode select switch. Refer to Removal and Installation.
Component Inspection
2WD models
CHECK DRIVE MODE SELECT SWITCH
Ignition switch OFF.
Disconnect drive mode select switch harness connector.
Check the continuity between drive mode select switch terminals as follows.
2WD models Drive mode select switch Condition Continuity Terminals 1 2 Switch to down-position. Existed Other than the above. Not existed 6 Switch to up-position. Existed Other than the above. Not existed
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace drive mode select switch. Refer to Removal and Installation.
4WD models
CHECK DRIVE MODE SELECT SWITCH
Ignition switch OFF and wait at least 10 seconds.
Ignition switch ON.
Check the indicator of AUTO on drive mode select switch indicator.
Check the illuminated position changes according to the operation when switching the drive mode select switch.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Replace drive mode select switch. Refer to Removal and Installation.