Defogger - Removal and Installation
- Filament
- Condenser
Filament Nissan Pathfinder SUV
Inspection and Repair
INSPECTION
When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger.

Attach probe circuit tester (in Volt range) to middle portion of each filament.

If a filament is burned out, circuit tester registers 0 or battery voltage.

To locate burned out point, move probe left and right along filament. Test needle will swing abruptly when probe passes the point.
REPAIR
REPAIR EQUIPMENT
Conductive silver composition (Dupont No. 4817 or equivalent)
Ruler 30 cm (11.8 in) long
Drawing pen
Heat gun
Alcohol
Cloth
REPAIRING PROCEDURE
Wipe the broken heat wire and its surrounding area clean with a cloth dampened in alcohol.

Apply a small amount of conductive silver composition to the tip of drawing pen.
Place ruler on glass along broken line. Deposit conductive silver composition on break with drawing pen. Slightly overlap existing heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
After repair has been completed, check repaired wire for continuity. This check should be conducted 10 minutes after silver composition is deposited.

Apply a constant stream of hot air directly to the repaired area for approximately 20 minutes with a heat gun. A minimum distance of 3 cm (1.2 in) should be kept between repaired area and hot air outlet.

Condenser Nissan Pathfinder R53
Removal and Installation
REMOVAL
Remove the back door lower finisher. Refer to Removal and Installation.
Disconnect the harness connectors (A) from the condenser (1).

Remove the bolt (B) and the condenser (1).
INSTALLATION
Installation is in the reverse order of removal.