Power Supply, Ground & Circuit Elements - System Description
- Component Parts. Electrical Units Location
- System. Power Supply, Ground & Circuit Elements
Component Parts. Electrical Units Location Nissan Pathfinder R53
Component Parts Location

- Battery
- Fuse, Fusible Link and Relay Box
- Fusible Link Box (Battery)
- IPDM E/R (Intelligent Power Distribution Module Engine Room)
- Fuse Block (J/B)
System. Power Supply, Ground & Circuit Elements Nissan Pathfinder 5th Gen
Harness Connector
HARNESS CONNECTOR (TAB-LOCKING TYPE)
The tab-locking type connectors help prevent accidental looseness or disconnection.
The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the figure below.
Refer to the next page for a description of the slide-locking type connector.
[Example]

HARNESS CONNECTOR (SLIDE-LOCKING TYPE)
A new style slide-locking type connector is used on certain systems and components, especially those related to OBD.
The slide-locking type connectors help prevent incomplete locking and accidental looseness or disconnection.
The slide-locking type connectors are disconnected by pushing or pulling the slider. Refer to the figure below.
[Example]

HARNESS CONNECTOR (LEVER LOCKING TYPE)
Lever locking type harness connectors are used on certain control units and control modules such as ECM, ABS actuator and electric unit (control unit), etc.
Lever locking type harness connectors are also used on super multiple junction (SMJ) connectors.
Always confirm the lever is fully locked in place by moving the lever as far as it will go to ensure full connection.

| 1. | Control unit with single lever A. Fasten B. Loosen C. Lever |
2. | Control unit with dual levers A. Levers B. Fasten C. Loosen |
3. | SMJ connector A. Lever B. Fasten C. Loosen |
HARNESS CONNECTOR (DIRECT-CONNECT SRS COMPONENT TYPE)
SRS direct-connect type harness connectors are used on certain SRS components such as air bag modules and seat belt pre-tensioners.
Always pull up to release black locking tab prior to removing the connector from SRS components.
Always push down to lock black locking tab after installing connector to SRS components. When locked, the black locking tab is level with the connector housing.

HARNESS CONNECTOR (SLIDE DOUBLE LOCKING SRS COMPONENT TYPE)
A new style slide double locking type connector is used on certain systems and components, especially those related to air bag control systems.
The slide double locking type connectors help prevent incomplete locking and accidental looseness or disconnection.
The slide double locking type connectors are disconnected by pushing or pulling the slider. Refer to the figure below.

Standardized Relay
NORMAL OPEN, NORMAL CLOSED AND MIXED TYPE RELAYS
Relays can mainly be divided into three types: normal open, normal closed and mixed type relays.

TYPE OF STANDARDIZED RELAYS
| 1M ···················· 1 Make | 2M ···················· 2 Make |
| 1T ···················· 1 Transfer | 1M·1B ···················· 1 Make 1 Break |

