Basic Inspection - Fuel Pressure Check ++
Work Procedure
FUEL PRESSURE RELEASE
FUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
On CONSULT screen, select “ENGINE”>>“Active Test” >> “FPCM”.
Start engine.
After engine stalls, crank it two or three times to release all fuel pressure.
Turn ignition switch OFF.
Without CONSULT
Pull out 20A fuse (No.85) from IPDM E/R. Refer to IPDM E/R Terminal Arrangement .
Start engine.
After engine stalls, crank it two or three times to release all fuel pressure.
Turn ignition switch OFF.
Reinstall fuel pump fuse after servicing fuel system.
INSPECTION END
LOW FUEL PRESSURE CHECK
FUEL PRESSURE CHECK
Release fuel pressure to zero.
Prepare fuel hose for fuel pressure check (B) and fuel tube adapter [SST: KV10120000 (-)] (D), then connect fuel pressure gauge (commercial service tool) (A).


: To quick connector 
: To fuel tube (engine side) C : Clamp Remove fuel hose.
Connect fuel hose for fuel pressure check
to fuel tube (engine side)
with clamp
as shown in the figure.
Connect fuel tube adapter (B) to quick connector
.
A : Fuel pressure gauge Turn ignition switch ON and check for fuel leakage.
Start engine and check for fuel leakage.
Stop the engine.
Turn ignition switch ON and read the indication of fuel pressure gauge.
With ignition switch ON and engine stopped : Approximately 450 kPa (4.5 bar, 4.59 kg/cm2, 65.25 psi)
Is the inspection result normal?
YES>>INSPECTION END
NO>>GO TO 2.
CHECK FUEL HOSES
Check the following.
Fuel hoses for clogging
Fuel filter for clogging
Low pressure fuel pump
Fuel pressure regulator for clogging
Is the inspection result normal?
YES>>Replace fuel pressure regulator.
NO>>Repair or replace error-detected parts.
HIGH FUEL PRESSURE CHECK
With CONSULT
Start engine.
Check “FUEL PRES SEN V” in “Data Monitor” mode of “ENGINE”.
Monitor Item Condition Values/Status FUEL PRES SEN V Engine: After warming up
Selector lever: P or N
Air conditioner switch: OFF
No load
Idle 1.120 – 1.310 V 2,000 rpm 1.215 – 1.425 V
Without CONSULT
Start engine.
Check fuel rail pressure sensor voltage.
| ECM | Condition | Voltage | ||
|---|---|---|---|---|
| Connector | + | − | ||
| Terminal | ||||
| F78 | 47 | 85 | [Engine is running]
|
1.12 – 1.31 V |
[Engine is running]
|
1.22 – 1.42 V | |||