Lan System - Can
- How to Use This Manual. How to Use This Section
- Precautions
- Wiring Diagram. Can System
How to Use This Manual. How to Use This Section Nissan Pathfinder 5th Gen
Caution
This section describes information peculiar to a vehicle and inspection procedures.
For trouble diagnosis procedure, refer to Trouble Diagnosis Flow Chart.
Abbreviation List
Unit name abbreviations in CONSULT CAN diagnosis and in this section are as per the following list.
| Abbreviation | Unit name |
|---|---|
| 4WD | 4WD control unit |
| 8ch GW 2 | 8CH CAN gateway |
| A-AMP. | BOSE speaker amp. |
| A-BAG | Air bag diagnosis sensor unit |
| ABS | ABS actuator and electric unit (control unit) |
| ADP | Driver seat control unit |
| AV | AV control unit |
| AVM | Around view monitor control unit |
| BCM | BCM |
| CCM | Chassis control module |
| DLC | Data link connector |
| E-HUD | Head Up Display unit |
| E-SHIFT | Electric shift control module |
| ECM | ECM |
| EPS/DAST 3 | EPS control unit |
| EVTC | Electric intake valve timing control module |
| HFM | Intelligent Key unit |
| HVAC | A/C auto amp. |
| ICC 2 | ADAS control unit 2 |
| IPDM-E | IPDM E/R |
| IVC | TCU |
| LANE | Front camera unit |
| LASER | Distance sensor |
| M&A | Combination meter |
| PWBD | Automatic back door control unit |
| RDR-L | Side radar LH |
| RDR-R | Side radar RH |
| SC CM | Automatic drive positioner control unit |
| SONAR | Sonar control unit |
| STRG | Steering angle sensor |
| TCM | TCM |
| WL CHG | Wireless charger unit |
Precautions Nissan Pathfinder SUV
PRECAUTIONS FOR SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG AND SEAT BELT PRE-TENSIONER : Precautions
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.
Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.
Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.
Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always place the ignition/power switch in the OFF position, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
With the adoption of Auto ACC function, ACC power is automatically supplied by operating the Intelligent Key or remote keyless entry or by opening/closing the driver side door. In addition, ACC power is supplied even after the ignition switch is turned to the OFF position, i.e. ACC power is supplied for a certain fixed time.
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.

For Nissan Pathfinder vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON the ignition switch.
After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the Nissan Pathfinder vehicle and close the driver side door.
Wait at least 3 minutes.
Remove 12V battery terminal.
Precautions for Trouble Diagnosis
Precautions for Harness Repair
Solder the repaired area and wrap tape around the soldered area.

Bypass connection is never allowed at the repaired area.

Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.
Wiring Diagram. Can System Nissan Pathfinder Fifth generation
Wiring Diagram
CAN SYSTEM
Refer to Wiring Diagram.