Seat - Third Row Seats
In this manual: Seat - Third Row Seats
~2min read
Exploded View

| 1. | Headrest pull strap finisher | 2. | Headrest (center) | 3. | Headrest (RH/LH) |
| 4. | Headrest holders | 5. | Seatback trim (RH) | 6. | Seatback trim (LH) |
| 7. | Seatback release lever finisher (RH/LH) | 8. | Seatback release lever and cable (RH) | 9. | Seatback hinge finisher (RH) |
| 10. | Seat harness | 11. | Seat bolt cover | 12. | Seat hinge finisher (center) |
| 13. | Seat belt buckle (RH) | 14. | Seat belt buckle (center/LH) | 15. | Center seat hinge bracket |
| 16. | Seat cushion trim | 17. | Seat cushion frame assembly | 18. | Seat hinge finisher (LH) |
| 19. | Seatback release lever and cable (LH) | 20. | Seatback release cable cover (LH) | 21. | Seatback release cable cover (center) |
| 22. | Seatback hinge flap | 23. | Seatback hinge plate | 24. | Seat hinge finisher bracket (center) |
| 25. | Seatback release cable cover (RH) | 26. | Seat hinge finisher bracket (RH) | 27. | Seatback hinge assembly |
| 28. | Seatback frame assembly (RH) | 29. | Seatback side inner cover | 30. | Seatback frame assembly (LH) |
| 31. | Seat hinge finisher bracket (LH) | 32. | Jack mounting bracket | 33. | Seatback board (LH) |
| 34. | Seatback pull strap (LH/RH) | 35. | Seatback board (RH) | 36. | Tether anchor finisher |
| A. | Seatback pad (RH) | B. | Seatback pad (LH) | C. | Refer to Removal and Installation. |
| D. | Seat cushion pad | E. | Refer to Seatback. |
Removal and Installation
REMOVAL
Remove front seat bolt covers (1) from seat assembly (2).

![]() |
: Front |
![]() |
: Pawl |
Remove bolts (A) from seat assembly (1).

![]() |
: Front |
Remove storage box. Refer to Removal and Installation.
Remove tire jack assembly.
Remove bolts (A) and remove jack bracket (1).

![]() |
: Front |
Remove bolts (A) from seat assembly (1) and seat belt buckles (2).

![]() |
: Front |
Disconnect seat belt buckle harness connector (A).

![]() |
: Front |
Remove seat assembly through the rear of the Nissan Pathfinder vehicle.
INSTALLATION
Installation is in the reverse order of removal.
When installing the third row seat, tighten the bolts to specification in the order shown.


: Front Bolts : 48 N·m
Was this page helpful?





