Road Wheels & Tires - Periodic Maintenance
- Wheel
- Wheel and Tire
Wheel Nissan Pathfinder 5th Gen
Inspection
Check tires for wear and improper inflation.
Check wheels for deformation, cracks and other damage. If deformed, remove wheel and check wheel runout.
Remove tire from wheel and mount wheel on a balancer machine.

| Lateral runout (A) | : Refer to Wheel. |
| Radial runout (B) | : Refer to Wheel. |
Wheel and Tire Nissan Pathfinder 5th Gen
Adjustment
BALANCING WHEELS (ADHESIVE WEIGHT TYPE)
Preparation Before Adjustment
Remove inner and outer balance weights from the wheel. Using releasing agent, remove double-faced adhesive tape from the wheel.
Wheel Balance Adjustment
If a balancer machine has an adhesive weight mode setting, select the adhesive weight mode setting and skip Step 2 below. If a balancer machine only has the clip-on (rim flange) weight mode setting, follow Step 2 to calculate the correct size adhesive weight.
Set wheel and tire on balancer machine using the center hole as a guide. Start the balancer machine.
For balancer machines that only have a clip-on (rim flange) weight mode setting, follow this step to calculate the correct size adhesive weight to use. When inner and outer imbalance values are shown on the balancer machine indicator, multiply outer imbalance value by 5/3 (1.67) to determine balance weight that should be used. Select the outer balance weight with a value closest to the calculated value above and install in to the designated outer position of or at the designated angle in relation to the wheel and tire.
Indicated imbalance value × 5/3 (1.67) = balance weight to be installed

Calculation example:
23 g (0.81 oz) × 5/3 (1.67) = 38.33 g (1.35 oz) ⇒ 40 g (1.41 oz) balance weight (closer to calculated balance weight value)
Example:
37.4 ⇒ 35 g (1.23 oz)
37.5 ⇒ 40 g (1.41 oz)
Install balance weight in the position shown.

When installing balance weight (1) to wheel and tire, set it into the grooved area (A) on the inner wall of the wheel and tire as shown so that the balance weight center (B) is aligned with the balancer machine indication position (angle) (C).
If calculated balance weight value exceeds 50 g (1.76 oz), install two balance weight sheets in line with each other as shown.

Start balancer machine again.
Install balance weight on inner side of wheel and tire in the balancer machine indication position (angle).
Start balancer machine. Make sure that inner and outer residual imbalance values are 5 g (0.17 oz) each or below.
If either residual imbalance value exceeds 5 g (0.17 oz), repeat installation procedures.
| Wheel balance | Dynamic (At flange) | Static (At flange) |
|---|---|---|
| Allowable imbalance | Refer to Wheel. | |
Rotation
Follow the maintenance schedule for tire rotation service intervals. Refer to Explanation of General Maintenance (FOR USA AND CANADA) or to General Maintenance (FOR MEXICO).

Rotate the wheels and tires front to back in the pattern as shown.
When installing the wheel, tighten the wheel nuts to the specified torque.
Wheel nut tightening torque : Refer to Exploded View.