Battery tray
In this manual: Battery tray
3steps
~18min
2/5difficulty
Done 0 of 3
Assembly overview - battery tray
- Front battery tray
- Rear battery tray
- Bonded areas
- Cannot be restored

Renewing battery tray
WARNING
Gases/vapours hazardous to health are generated when welding, soldering or cutting using tools which produce sparks in foam-treated areas.
- Do not weld, solder or cut closer than 15 mm to moulded foam inserts.
- Use an extraction system during work.
Observe safety information ⇒ Rep. gr. 00; Safety information Only tools and workshop equipment authorised by Volkswagen AG may be used ⇒ 2.1
Removing
- Separate original joint.

- Remove front battery tray -1-.
- Remove rear battery tray -2-.
- Remove remaining material.

- Completely remove remaining adhesive.
- Grind welding surfaces back to bare metal and clean.
Installing
- Drill holes (8 mm diameter) for SG plug weld seam in new part -1- and -2-.

- Adjust new part -1- and -2- to fit and fix in position.

- Check fit with add-on parts.
- Weld in new part -1- and -2-, SG plug weld seam.
Was this page helpful?