Longitudinal member cross panel
In this manual: Longitudinal member cross panel
~1min read
Assembly overview - front longitudinal member cross panel
Overview is shown for left side of vehicle as an example
- Front longitudinal member cross panel
- ⇒ Rep. gr. 50; Renewing front longitudinal member cross panel

Renewing front longitudinal member cross panel
WARNING
Gases/vapours hazardous to health are generated when welding, soldering or cutting using tools which produce sparks in foam-treated areas.
- Do not weld, solder or cut closer than 15 mm to moulded foam inserts.
- Use an extraction system during work.
NOTICE
If adhesive is applied prematurely, bond could be impaired
- New part must be welded in within 90 minutes.
Observe safety information ⇒ Rep. gr. 00; Safety information Only tools and workshop equipment authorised by Volkswagen AG may be used ⇒ 2.1 , page 2 .
Removal and installation are described for left side of vehicle as an example.
Removing
- Separate original joint.

- Remove front longitudinal member cross panel -1-.
- Remove remaining material.

- Completely remove remaining adhesive.
- Grind bonding surfaces and welding surfaces back to bare metal and clean.
Installing
Important
- New parts must be adapted and attached with the vehicle standing on straightening bracket set.
- Grind welding surfaces on new part -1- down to bare metal and clean.

- Adapt new part -1- to fit and fix in position.

- Check fit with add-on parts.
- Weld in new part -1-, SG plug weld seam.
Was this page helpful?