Gearbox housing, clutch housing
In this manual: Gearbox housing, clutch housing
4steps
~24min
2/5difficulty
Done 0 of 4
Assembly overview - gearbox housing
- Three-phase current drive - VX54- with gearbox
- Upper sealing cap
- ⇒ Rep. gr. 34 ; Removing and installing cap
- Lower sealing cap
- ⇒ Rep. gr. 34 ; Removing and installing cap
- Plug for gear oil filling and inspection hole
- Renew after removing
- 45 N·m

Removing and installing cap
Special tools and workshop equipment required
- thrust pad - 3062-
Removing
Important
- Lower motor with gearbox by 150 mm to renew the upper cap ⇒ Electric rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220; Rep. gr. 10 ; Removing and installing rear motor; Removing motor .
- Upper sealing cap
- Lower sealing cap
- Pierce centre of cap to be removed with screwdriver -A-, and carefully pry out cap.

Installing
Install in reverse order of removal, observing the following:
- Drive in upper cap -1- or lower cap -2- with thrust pad - 3062- -A- so that it is flush.

Was this page helpful?